Question No. 1

You are adding peers to a Policy-Based Realm Bridging (PBRB) configuration.

Which two configuration steps, among others, are required? (Choose two.)

ANavigate to the media-manager configuration branch and configure the realm-config configuration element.

BNavigate to the session-router configuration branch and configure the sipd-address configuration element.

CNavigate to the session-router configuration branch and configure the local-policy configuration element.

DNavigate to the session-router configuration branch and configure the sip-nat configuration element.

ENavigate to the media-manager configuration branch and configure the access-control configuration element.

Show Answer

Correct Answer: A, E

Question No. 2

You are logged in to the Session Border Controller a superuser. You want to remove other user from the system.

How do you accomplish this?

Afrom the superuser mode, by executing the remove user <index number> command

Bfrom the user mode, by executing the kill <index number> command

Cfrom the superuser mode, by executing the remove user <username> command

Dfrom the superuser mode, by executing the kill <index number> command

Efrom the user mode, by executing the remove user <index number> command

Show Answer

Correct Answer: C

Question No. 3

Where are passwords and licensing information stored?

ANon-Volatile Random Access Memory (NVRAM)

BContent Addressable Memory (CAM)

CRAM memory

DSynchronous Dynamic Random Access Memory (SDRAM)

EBoot Flash

Show Answer

Correct Answer: A

Question No. 4

View the Exhibit.

Which statement is true about this output of the show health command?

AThe two nodes have different health scores.

BThe training1 peer is the standby node.

CThe switchover berpd force command was executed to do a manual failover.

DThe training6 peer is the active node.

EThe training6 peer will wait 1050 ms before considering the training1 peer out of service.

Show Answer

Correct Answer: E

Question No. 5

Which configuration step is correct for a phy-interface configuration element used for signaling and/or media?

AA phy-interface element must be configured for each interface used for High Availability (HA) heartbeats, but not for signaling and/or media.

BAfter configuring a phy-interface configuration element for signaling and/or media, a reboot of the Session Border Controller is required.

CA phy-interface configuration element must be configured for each interface used.

DA unique phy-interface configuration element is created for all signaling/media interfaces.

EA phy-interface configuration element for signaling and/or media has the operation-type parameter set to control.

Show Answer

Correct Answer: B

Free Oracle 1Z0-404 Exam Actual Questions

The questions for 1Z0-404 were last updated On Dec 18, 2024