What are two requirements to use the Wired Visibility option of Juniper Mist Wireless Assurance? (Choose two.)
Cloud-ready Switch: To use the Wired Visibility option in Juniper Mist Wireless Assurance, a cloud-ready switch must be deployed in the network. This ensures that the switch can communicate effectively with the Mist cloud for management and monitoring.
SNMP Protocol Configuration: The Simple Network Management Protocol (SNMP) must be configured on the switch. SNMP enables the monitoring and management of network devices, allowing Mist AI to collect necessary data for visibility and assurance.
Which two configuration levels are WLAN objects created? (Choose two.)
Site Level: WLAN objects can be created at the site level, allowing specific configurations for different locations within an organization. This helps in customizing WLAN settings based on the unique requirements of each site.
Org Level: WLAN objects can also be created at the organization level, which provides a standardized configuration that can be applied across multiple sites. This ensures consistency in WLAN settings throughout the entire organization.
Juniper Mist WLAN Configuration Guide
Site and Org Level Configration.
ten protocol is used by Mist lo monitor non-Juniper switches?
The Simple Network Management Protocol (SNMP) is used by Mist to monitor non-Juniper switches. SNMP is a widely adopted protocol for network management, enabling the collection and organization of information about managed devices on IP networks.
Juniper Mist Monitoring Documentation
SNMP Configuration Guide
When browsing the Marvis Actions page, you notice that something has triggered the "AP Online" Marvis Action. You click on that action at information will you see displayed? (Choose two.)
When browsing the Marvis Actions page and you click on the 'AP Online' Marvis Action, you will see:
Marvis Action Status: This indicates the current state of the action, whether it is in progress, resolved, or another status.
Recommended Action: Marvis will provide a suggested course of action to resolve the issue. This could include steps like configuration changes or other remedial actions.
Manager asks you to set up a new WLAN that Is Open Access and does not allow any connected clients to communicate with each other, m the WLAN configuration, which feature would you use to separate the clients?
To set up a new WLAN that is Open Access and prevents connected clients from communicating with each other, you should use the Configure Isolation feature. This feature, often referred to as client isolation, ensures that each client can only communicate with the access point and not with other clients on the same WLAN.
Juniper Mist WLAN Configuration Guide
Best Practices for WLAN Security
